After making a couple warm water, warm weather tuna runs this season, I decided to see just how long this aluminum hull would hold a belly full of shaved ice. Keep in mind that this was late August and we had temps in the 80's for most of that time.
Day One: Filled the box with ice in the morning and although we only got five tuna it still gave us a starting place for the "Ice Test" I added a few buckets of sea water to make room for the tuna.
- IMG_1164 (Small).JPG (79.8 KiB) Viewed 11256 times
Day Two: Tuna out and some noticeable melt. I pumped out the melt water and hosed the edges with fresh water to clean the box a bit.
- IMG_1165 (Small).JPG (47.04 KiB) Viewed 11256 times
Day Three: There's still about half of the surface of the fishbox covered with ice and if need be, I would have been fine with going for a tuna run with that three-day old, but cold fishbox!
- IMG_1170 (Small).JPG (75.45 KiB) Viewed 11256 times
To be completely honest, I was pleasantly surprised with the cold-holding performance of this insulated aluminum fishbox. Is it a Yeti cooler? heck no!
Can you bolt a Evinrude outboard to a Yeti?... I don't think so...
